HOW TO USE SONICWALL NETEXTENDER HOW TO
HOW TO USE SONICWALL NETEXTENDER INSTALL
HOW TO USE SONICWALL NETEXTENDER PASSWORD

To Set up the SonicWall to enable Password changes we first need to go (in Classic Navigation Mode) Users / Settings / Authentication and Select Configure RADIUS, then ADD, enter your Servers IP address and the Shared Secret chosen to match the one entered on the NPS RADIUS Client.Дў.

ThatвЂ™s the Server side set up, you can repeat on a backup server if needed.ДЎ. Once you have configured everything, I would recommend restarting the NPS Service after any changes, you can do this by right clicking on the main NPS icon and selecting Stop NPS Service, wait a few seconds for it to refresh then select Start NPS Service.ДЎ8. Next, we need to disable the Default Policy Profiles, it is the same procedure for the Connection and the both the default Network Policies, right click on the policies and select Disable.ДЎ7. We need to register NPS in Active Directory, Select Action from the top menu and then Register server in Active Directory.ДЎ6. Next Check the Settings are correct and the Finish.ДЎ5. On configure Constraints and Configure Settings leave as default.ДЎ4. Select Access Granted and select the Authentication Methods as below MSCHAP and MSCHAPv2.ДЎ3.

We choose the group which has all our SSL VPN users in.ДЎ2. This time under the condition we select User Groups.ДЎ1.

Next, we need to set up the Network Policy like the previous one right click and select New.ДЎ0. You donвЂ™t need to add any Attributes just select next and finish.Д©. Leave the Authentication settings and Methods as Default.ДЁ. Specify the conditions to connect, in this case we chose the NAS IPv4 Address and enter the IP address of the SonicWall LAN IP which is on the same subnet as the server.Д§. Once loaded we need to create the Connection Policy and the Network Policy, right click on the Connection Policies in the Policies section and select New.Д¦. To start we set up the Radius Client, in our case the connecting IP address which will be the SonicWall LAN IP, right click on RADIUS Clients and select new, give it a name, enter your required IP and a Shared Secret of your choice.Д¤. Run the NPS by going to either Server Manager / Tools / Network Policy Server or by selecting from the Start Menu / Windows Administrative Tools / Network Policy Server.ДЈ.

HOW TO USE SONICWALL NETEXTENDER INSTALL

We will need to Install NPS if not already installed, to do this go to Server Manager, select Add Roles and Features and Select Network Policy and Access Services, continue with the Wizard only selecting Network Policy And Access Services.Дў. If not refer to this document on the link below firstДЎ.

This document presumes you have already set up the LDAP(S) connection between the SonicWall and the Server.

Check also if any other Application is using the default RADIUS ports on the server by doing a netstat -ab from the command prompt, if UDP 18 are already listed you will need to change on the NPS Radius Client Advanced settings and the SonicWall RADIUS Settings.

It is recommended to use LDAPS 636 for the communication between the SonicWall and the AD Server(s).

To enable password changes the SonicWall and the Server need to use MSCHAPv2.

This document is created based on 6.5 firmware but the procedures are the same with previous versions of SonicOS.

HOW TO USE SONICWALL NETEXTENDER HOW TO

How to enable users to change expired Passwords on SonicWall UTM Appliances using SSLVPN.

How to use sonicwall netextender